Registrieren Anmelden

Operating instructions WRG 3010 E (S. 28/114)

Operating instructions WRG 3010 E (S. 28/114)

Operating instructions WRG 3010 E (S. 28/114)

Erste Seite

Vorige Seite

Nächste Seite

Letzte Seite

Übersicht aller Seiten

Vollbildanzeige

Das Dokument wird geladen...

Punktgenauer Marker

Erste Seite

Vorige Seite

Nächste Seite

Letzte Seite

Übersicht aller Seiten

Vollbildanzeige

Inhaltsverzeichnis

Conventions

Warning signs, symbols and text formatting used in this manual
Explanation of text formatting

Safety instructions

Disclaimer in the event of non-compliance
Requirements for the personnel
Intended Use
Five safety rules according to DGUV Regulation 3
Electrostatic-sensitive components and control components (ESD)

ESD - Rules for handling and working

Abbreviations used

System Design of WRG 3010 E

Connections

Application of WRG 3010 E
Function of WRG 3010 E

High Temperature Heat Recovery HT
Low Temperature Heat Recovery LT
Air conditioning operation
Power Signal
Desuperheating
Pressure boost
Gas cooler fan switch-off
Gas cooler bypass GCBP
Air heat pump LWP
Archiving of operating data
Calibration of the Pt1000 Temperature Sensor
Service Area Analogue Inputs and Outputs
Troubleshooting

Installation and Start-Up of WRG 3010 E

Top-Hat Rail Mounting

Mounting on the DIN Rail
Removal from the DIN Rail
Handling Wide COMBICON Plugs

SIOX Extension Module - for Top-Hat Rail Mounting

Connection of the SIOX modules to the controller

Basic Settings Hardware

Settings via DIP Switch S1
Setting the CAN Bus Address Using Decade Switch S2
Setting of the Interface RS485/TTY Using Jumper J1
Configuration of the Analogue Inputs and Outputs at the Factory
Power Supply

Status LEDs

Quick Commissioning
Battery replacement
Firmware Update

Requirements for firmware update
Update of the current firmware

Pin and Terminal Assignments of WRG 3010 E

Connections for 230 V AC (top)

Terminal Assignment of the 230 V AC Power Supply
Terminal Assignment of the Relay Outputs - 230 V AC
Terminal Assignment of the Digital Inputs - 230 V AC

Connections for Protective Extra-Low Voltage (bottom)

Terminal Assignment of the Analogue Inputs
Terminal Assignment of the Analogue Outputs

Connections for Interfaces (on the side)

Terminal Assignment of CAN Bus
Terminal Assignment of RS232 and TTY
Terminal Assignment of RS485
Terminal Assignment of SIOX

Manual/Automatic Operating Modes
Operation of WRG 3010 E

Integration in LDSWin
Visualisation in LDSWin - WRG 3010 E
Visualisation in LDSWin - HT / LT / Power Signal Setpoints
Visualisation in LDSWin - GCBP / LWP / air conditioning operation setpoints
Visualisation in LDSWin - Service Area

Decommissioning and disposal

Decommissioning / Dismantling
Disposal

Alarms and messages of WRG 3010 E

Message system
Display of the Messages and Alarms in the System Centre

Technical Data WRG 3010 E

Electrical data
Mechanical Data WRG 3010 E

Order numbers and accessories of WRG 3010 E

Controller for heat recovery WRG 3010 E
Accessories for WRG 3010 E

Technisches Handbuch FBM AIO22 - 1.0

Technical manual FBM AIO22 - 1.0